Reviews Output Module

LoadHandler Truck Bed Unloader - LH3000 - Fits Full Size Trucks

  • Very small size, length, width and height are 17*11*3.6mm.
  • The maximum output current can reach 1.8A, when the output current is 1.5A, the output voltage is 3V.
  • Switching frequency: 1.5 MHz (highest), typically 1 MHz.
  • When using this module with an inductive load, please pay attention to the protection of the current in the rear stage. For example, when using a steering gear or a motor, a large ripple may be generated, which may affect the chips in the rear stage circuit. You can add Zener and capacitor for protection.
Check Stock

Taidacent Low Concentration Qualitative Detection MQ131 Ozone Sensor Module O3 Air Quality Monitoring

  • Mainly used for qualitative detection, suitable for home and environmental gas detection equipment, ozone gas detection, gas sensor test concentration....
  • The module has level signal output and alarm signal indicator.
  • The module is with analog signal output, voltage range: 0-5V.
  • The level signal output is effective at low level, which can drive PNP transistors and can also be connected to the IO port of the microcontroller.
  • The analog output voltage increases with the increase of ozone concentration, the higher the concentration, the higher the voltage.
Check Stock

Alinan 10pcs High Sensitivity Sound Microphone Sensor Detection Module for AVR PIC

  • Using infrared reflective sensor TCRT5000.
  • TCRT5000 infrared reflection sensor, detecting reflection distance, suitable for 1mm~25mm, comparator output, clean signal, good waveform, strong driving ability, over 15mA, with potentiometer adjustment sensitivity.
  • IR Infrared Obstacle Avoidance Sensor Module TCRT5000 Photoelectric Switch Barrier Line Track Sensor Module for Smart Car w/Cable 3.3V-5V.
  • Easily Installation:Design with bolt holes for easy installation.Use wide voltage LM393 comparator,With potentiometer to adjust sensitivity.
  • Output form: digital switching output (0 and 1),Comparator output, clean signal, good waveform, strong drive capability, over 15mA.
Check Stock

20 Pieces 3 Pins AMS1117-3.3 DC 4.75V-12V to 3.3V Voltage Regulator Down Power Supply Buck 800mA Module

  • How to install: please check the product pictures carefully for the wiring diagram steps before using, simple dual-panel design and the input output using the 3 pin single row pin for easy connection, the input voltage is higher than output voltage 1.2V, the module will work normally.
  • AMS1117-3.3 is a positive voltage regulator step down power supply module, support DC 4.75-12V input and 3.3V fixed voltage and 0.8A current output.
  • Electronic devices partner: the 3 pins AMS1117-3.3 voltage regulator mini step down power supply module, can be applied to electronic devices which need 3.3V power supply, such as SCM project design, MCU development and more, easy to be connected and provide the power supply.
  • Where to use: the voltage to 3.3V 800mA DC buck module is applicable for high-efficiency linear regulator published active power regulator battery charger active instrument.
  • Compatible with: the 3 pins AMS1117-3.3 voltage regulator mini power supply is compatible with Arduino MEGA2560, MSP430 development board, 3.3V low power consumption MCU, FPGA/CPLD PLD programmable logic systems, ARM7 ARM9 ARM11 STM32, etc..
  • Provide more safety: the AMS1117-3.3 800mA DC buck module features overheat shutdown circuit provides overload and over-temperature protectio....
Check Stock

16mA Logarithmic Amplifier Module 100 DB Amplifier Board 5MHZ‑500MHZ SMA Detector Module for FSK PSK Demodulation Signal Reception

  • Logarithmic Amplifier Module: Logarithmic output of the logarithmic amplifier module is proportional to the logarithm of the input signal..
  • RSSI Linearity: ±0.4 dB RSSI linearity, RSSI scale does not change with temperature and feed voltage..
  • Apply to: Used for received signal strength indicator (RSSI) and phase detection in cellular base stations, radar and other radio transceiver applications..
  • Specific Parameters: 16mA current, 20 mV/dB slope, ‑95 dBm intercede, SMA female, 5MHZ‑500MHZ frequency range, 100 dB gain. Dynamic Range: 100 dB -78 dBm to +22 dBm (Re 50 O). Total Gain: 100 dB. Bandwidth: 500 MHz. Sleep Current: 003c1mA..
  • Founction: AD8309 amplifier module, with limiting output, can be used as FSK PSK demodulation. Input and Output Interface: SMA Female..
Check Stock

WayinTop 2pcs ACS712 Hall Effect Current Sensor Module 30A Range ACS712 Module + 2pcs Voltage Sensor Module DC0-25V Voltage Tester Terminal Sensor for Arduino

  • 【Perfect Combination】Using this product can measure both voltage and current, very suitable for DIY electronic design projects..
  • 【Current Sensor Module】Chip: ACS712ELC-30A.
  • Pin 5V power supply, on-board power indicator.
  • The module can measure positive and negative current of 30 amperes, corresponding to analog output of 66mV/A..
  • 【Voltage Sensor Module】Voltage input range: DC0-25V.
  • DC input connector: Terminal cathode connected to VCC, GND negative pole.
  • Output interface: "+" then 5/3.3V, "-" then GND, "s" then the for Arduino AD pins..
  • 【Package Included】2 x ACS712 Hall Effect Current Sensor Module + 2 x Voltage Sensor Module DC0-25V Voltage Tester Terminal Sensor.
Check Stock

Dasiter 600W High Power DC to DC Boost Converter DC 12-60V to 12-80V Boost Module Board Step-up Transformer

  • 【DC to DC Boost Converter】600W high power booster module, wide voltage input: 10V ~ 60V, 12V ~ 80V adjustable wide voltage output.
  • ultra-low input and output pressure difference..
  • 【DC to DC Boost Converter】Specifications: Radiator bottom plate thickness 5mm, tooth height 21mm, length 85mm, width 63mm, booster plate fixed above the radiator, rational design, integrated design of radiator and booster plate, convenient for users to use directly, use long screws fixed directly..
  • 【DC to DC Boost Converter】The module has a constant voltage and constant current function, but it is a non-isolated boost mode, due to its characteristics, the constant current range depends on the input and output voltage and load..
  • 【DC to DC Boost Converter】Please Power on the module first, then connect the load, which is especially important in high-power loads.
  • the input voltage should be stable, especially when some low-voltage (12V) input power supply is connected to the load voltage, it will fall below 10V, and it is easy to break down the power tube at this time..
  • 【DC to DC Boost Converter】Two or more modules can not be used in parallel input and output, otherwise the current limit function will be invalid.
Check Stock

NOYITO Voltage to Current Module 0-10V to 0-20mA

  • NOYITO Voltage to Current module, 0-2.5V ,0-3.3V,0-5V,0-10V,0-15V,0-24V voltage signal conversion to 0-20mA or 4-20mA current signal output, by adjusting the voltage to adjust the size of the current. Can be used to generate the signal source, valve adjustment, inverter control, PLC debugging, instrumentation test, LED test, analog transmitter.003cbr003e.
  • Implement the industry standard voltage (0-2.5V ,0-3.3V,0-5V,0-10V,0-15V,0-24V) into an industry standard current (0-20mA, 4-20mA)., linear output, the output signal can be directly connected to the AD converter, with the AD function with the microcontroller connection.003cbr003e.
  • Using single-chip embedded technology. The module is small and easy to use in different places.003cbr003e.
  • Easy to use, can be fine-tuned by potentiometer.003cbr003e.
  • Module working voltage: DC12-24V . 【Please read the product pictures on the left side of the page for the wiring diagram of the product.】003cbr003e.
  • 【Manufacturer's One-year After-sale Warranty】.
Check Stock

Coliao 8pcs Microphone Sound Sensor KY-037 High Sensitivity Sound Voice Detection Module with Digital and Analog Output Sensors DIY Kit

  • Microphone sensor can be used to detect the sound intensity of ambient,with analog output and threshold level output flip.
  • Two outputs: AO, analog output, real-time output voltage signal of the microphone.
  • KY-037 high sensitivity sound microphone sensor detection module diy kit, good for PIC AVR.
  • Package includes: 8pcs sound detection sensor module.
Check Stock