ACEIRMC SG90 Servo Motor Micro Servo 9G Servo Motor for RC Robot Arm Helicopter Airplane Remote Control (5 Pcs) (5pcs)

  • SG90 9G micro servo motor for remote control helicopters, micro robot, robot arm and boats. Fit for ALL kind of R/C Toys and also make electronics DIY based on compatible for Arduino ,Raspberry Pi.
  • The SG90 mini servo motor is lightweight, high-quality and lightning-fast.The servo is designed to work with almost all the radio control systems..
  • SG90 Micro Servo Motor compatible for Mini Arduino Servo SG90 9g Servo Kit for RC Helicopter Airplane Car Boat Robot Arm/Hand/Walking/Servo Door Lock Control with Cable.
  • The SG90 has 3 wire interfaces in which the connections should be made as follows: Red wire-5V, Brown Wire-Ground, Yellow wire-digital pin 9..
  • Stall Torque (4.8V): 17.5oz /in (1kg/cm).
Check Stock

ACEIRMC 2pcs for MEGA 2560 PRO Embed CH340G/ATMEGA2560-16AU Chip with Male Pinheaders Compatible for Arduino Mega2560 Module

  • MEGA 2560 PRO Board Embed CH340G/ATMEGA2560-16AU Chip with Male pin headers, Compatible for arduino Mega2560 DIY.
  • Built on the Atmel ATmega2560 microcontroller and USB-UART interface chip CH340G..
  • Board have compact size 38x55mm. It is good solution, to make your final project on solder proto-board..
  • Board for functionality similar to the compatible for Arduino Mega 2560..
  • The board used the chip CH340G as converter UART-USB..
Check Stock

Treedix USB to TTL Converter CH340 Module 3.3V/5.5v Serial Converter Development Tool with Micro USB Adapter for Arduino

  • Serial Basic Breakout Board CH340G serial signal serial ic breakout development board usb micro b connector save space diy electronics projects micro b cable jumper wires.
  • Base on USB converter IC CH340G, there is a wide range of operating systems . You may need to install drivers the first time you connect the chip to your computer's USB port or when there are operating system updates..
  • The output voltage is 3.3v by default, there is a 3.3v signal, it can also be changed to 5V, changing to 5V will cause the board to output 5V and 5V signals on the VCC pin(3 .3v to 5V by a short circuit selection).
  • There are two LEDs on the board connected to TX (green) and RX (yellow) for faster viewing of serial traffic.
  • Suitable for: Arduino Pro Mini, our GPS module, cellular module and many other devices that use serial communication.
Check Stock

Geekworm UNO R3 Case | Protective Enclosure ABS Computer Box for Arduino UNO R3/UNO WiFi REV2/UNO REV3- Black

  • This ABS black case is perfect compatible with Arduino UNO R3 development board, UNO WiFi REV2 or UNO REV3. (Arduino UNO Case).
  • Case Size: 7.5cm x 6cm x 2cm (2.95inch x 2.36inch x 0.78inch).
  • It is design with two nice "+" holes and 10 "-" holes for cooling....
  • It is very easy to install and Mini & attractive body to carry everywhere..
  • Note: The UNO R3 board is not included in the packing list..
Check Stock

Geekworm UNO R3 Case | Protective Enclosure ABS Computer Box for Arduino UNO R3/UNO WiFi REV2/UNO REV3- Transparent

  • This Geekworm design ABS tranparent case is perfect compatible with Arduino UNO R3 development board, UNO WiFi REV2 or UNO REV3. (Arduino UNO Case).
  • Case Size: 7.5cm x 6cm x 2cm (2.95inch x 2.36inch x 0.78inch).
  • It is design with two nice "+" holes and 10 "-" holes for cooling system..
  • It is very easy to install and Mini & attractive body to carry everywhere..
  • Note: The UNO R3 board is not included in the packing list..
  • Packing List: 1x UNO R3 ABS Case-Transparent.
Check Stock

Mxzzand 3in Industrial Robot Parts Accessories Omnidirectional Wheel Metal 2Pcs for Industry Production with 10pcs Driven Roller

  • 1 Sketch Pack, 12 Snap Connectors, 1 Gripper Pair, 2 Bridge Connectors, 3 Cube Connectors, 1 L Connector, 1 U Connector. 2 Snap Connector Caps, 2 3" Rectangle Connectors, 2 4" Rectangle Connectors, 2 5" Rectangle Connectors, 2 T Connectors, 8 Colored Foam Cubes, various screws and nuts.
  • 2 Arduino-Uno-Compatible Boards, 1 USB A-B Cable, 1 Joystick, 1 RGB LED, 1 Ultrasonic Distance Sensor, 8 Red LEDs, 8 Green LEDs, 8 Blue LEDs, 8 Yellow LEDs, 2 7-Color LEDs, 2 GRB LEDs, 12 220 Ohm Resistors, 12 10k Ohm Resistors, 1 LDR VT90N2 Photoresistor, jumper wires, 3 10k Potentiometers, 1 Fullsize Breadboard, 6 Push Buttons.
  • 1 9V Battery Holder, 1 Mini Breadboard, 1 Linkbot-Arduino Cable, 1 2-in-1 Dual Phillips/Slotted Screwdriver, 3 Snap Connectors, 1 Cube Connector, 1 L Connector, 3 Mounting Plates, 2 Sensor Bracket, 1 Li-ion Rechargeable Battery,.
  • 1 Color Sensor, 2 Short Distance IR Distance Sensors,1 RGB LED Module with Common Positive Lead (Common Anode), 2 RGB LED Module with Common Negative Lead (Common Cathode), 2 Ultrasonic Range Sensors, 1 IR Range Sensor, 1 Cable for IR Range Sensor, 2 Light Sensors, 3 Line Following Sensors, 2 Touch Sensors, 4 Sensor Brackets, 4 Sensor Inserts, 1 Universal Pan-Tilt, 3 Pan-Tilt Mounts, PDF file....
Check Stock

Arduino The Official Starter Kit Deluxe Bundle with Make Getting Started The Open Source Electronics Prototyping Platform 3rd Edition Book

  • Includes The Only Official Arduino Starter Kit From Arduino, The Best Selling Book From Make Magazine: Getting Started with Arduino: The Open Source....
  • Includes Book, Make: Getting Started with Arduino: The Open Source Electronics Prototyping Platform Paperback.
  • Includes Arduino Uno R3 And Exclusive Speed-Kits Arduino PIN OUT Quick Reference Chart.
  • Includes a total of over 200 electronic parts and components.
Check Stock

Comimark 1Pcs GY NEO 6MV2 GPS Module NEO-6M GY-NEO 6MV2 Board with Antenna for Arduino New

  • This is GY NEO 6MV2 GPS Module NEO-6M GY-NEO6MV2 Board with Antenna for Arduino New,The default baud rate: 9600..
  • Non-brand New Chip, but the use of the same effect.,Module with antenna, mini size with strong signal..
  • EPROM save the configuration parameter data when power down,With data backup,With LED signal lights,Compatible with various flight control....
  • Package Included:1Pcs GY NEO 6MV2 GPS Module NEO-6M GY-NEO6MV2 Board with Antenna for Arduino New(If the number of products received is incorrect,....
  • We highly appreciate all customers opinions to improve the selling, also if anything you unsatisfied, please contact us for probable best solution..
Check Stock

SunFounder 2560 R3 Project Super Starter Kit with 2560 Controller Board and R3 Controller Board

  • For Arduino kits and Affordable Price - This is a complete Kit with more than 200pcs components for adults, students and beginners.. Includes 2560 controller board and USB cable, 100% compatible with Arduino Mega 2560 R3 Mega328 Nano for Arduino kit..
  • Detailed Instructions - This 2560 Kit with detailed pdf tutorial in the CD, you can learn to code and program faster and easier with all the components..
  • 25 Projects Provided - As an upgraded starter kit compatible with arduino 2560 controller board, more than 20 interesting lessons are included. Allowing for a dynamic creative learning experience..
  • Compatible with Arduino- R3 board compatible with Arduino,use ATMEGA16U2 chip, Faster transfer rates and more memory..
  • Control using r3 ATmega328P chip, Includes new pin configuration (SCL, SDA, IOREF) Clearly print on the female header connector, more precise and easier to use the wire..
Check Stock