Reviews Vacuum Compressor Units

Lisle 20300 Vacuum Gauge and Fuel Pump Tester

  • Easy reading gauge assures accurate vacuum and pressure check.
  • Vacuum Units: 0-25 inch Hg and 0-800 mm Hg.
  • Pressure Units: 0-14 PSI and 0-1000 g/cm2.
Check Stock

Fielect N.O 40℃ 5pcs Normally Open Temperature Switch, KSD-01F Thermal Switch Thermostat Temperature Controller

  • Defrost Two defrost modes are available through the td parameter: td=EL defrost through electrical heater (compressor OFF).
  • td=in hot gas defrost (compressor ON). Other parameters are used to control the interval between defrost cycles (id), its maximum length (Md) and two defrost modes: timed or controlled by the evaporator's probe. At the end of defrost dripping time is started, its length is set in the dt parameter. With dt=0 the dripping time is disabled.
  • SAFETY PRECAUTIONS Check the supply voltage is correct before connecting the instrument. Do not expose to water or moisture: use the controller only within the operating limits avoiding sudden temperature changes with high atmospheric humidity to prevent formation of condensation. ? Warning: disconnect all electrical connections before any kind of maintenance. ? Fit the probe where it is not accessible by the End User. The instrument must not be opened..
  • In case of failure or faulty operation send the instrument back to the distributor or to Dixell S.r.l.(see address) with a detailed description of the fault. Consider the maximum current which can be applied to each relay (see Technical Data). Ensure that the wires for probes, loads and the power supply are separated and far enough from each ....
Check Stock

GC America 003680 Capsule Mixer CM-II

  • 1. Vacuum Mixer is essential equipment for mixing and vibrating investment materials and molded materials in dental laboratory..
  • 2. As the mixing process is done in a vacuum state,the workpiece is free of bubbles and the firmness and compactness of the mold has also been improved. This machine uses a high class vacuum pump..
  • 3. It has the following characteristics: high vacuum power,strong mixing power,and adjustable vibration amplitude, no bubbles in invested casting rings, homogeneous, high density and high quality..
  • 4. The vacuum mixer is a bench-top structure that needs to be used with an air compressor together..
  • 5. It requires an external pump to pump vacuum, it does not have an oscillating function..
Check Stock

AstroAI Tire Inflator Air Compressor Portable DC/AC Air Pump Auto Tire Pump for Car Tires, 150PSI with LED Light for Cars, Balls, Motorcycles, and Other Inflatables Christmas Gift

  • AC/DC dual power supply design: Our portable air compressor’s multifunctional AC/DC dual power supply design can draw power from both vehicle and wall outlets. Its DC plug is designed for a 12V cigarette lighter socket while its AC plug is designed for a 110V/120V wall outlet.Includes 3 extra nozzles: Suitable for cars, motorbikes, bike tires, sports equipment, and other inflatable items. Our portable air compressor can be used indoors or on the road..
  • High pressure & fast inflation: The pump’s metal motor provides improved compression, allowing the unit to output up to 150 psi. Fill a 195/65/R15 tire from 0 psi to 36 psi in 5 minutes. Use our pump to inflate your tires and other inflatable devices quicker and easier. Note: Please let the compressor cool off for at least 10 minutes after every 15 minutes of use..
  • Auto-shutoff & memory function: The Air Compressor will automatically shut off when it reaches the pre-set pressure. The compressor will automatically save the pressure setting for next use..
  • HD screen with LED illumination: The bright digital backlit LCD screen provides excellent illumination at night. You can easily change the display’s units between PSI, BAR, and KG/CM²..
  • Space-saving and easy to store: The compressor’s power cords a....
Check Stock

Klimaire 2-Zone (9K BTU + 9K BTU) 21 SEER Ductless Multi-Zone Inverter Air Conditioner Heat Pump with 15 ft Installation Kits

  • Klimaire ultra high efficient 2-Zone 21 SEER ductless mini split inverter system includes 2 indoor units, an outdoor unit, remote control, and 2 -15 ft. Installation kits.(Free 25-ft installation kit upgrade if needed). Each indoor cools and heats an Area up to 350-400 sq. Ft.
  • Outdoor Unit is pre-charged and accommodates up to 25 ft length of refrigerant lines. Double cam twin rotary compressor and built-in compressor heater ensures the compressor longevity and reliability. Willing to.
  • 4 in 1 system: heating, cooling, fan and dehumidification modes. Turbo function, multi-speed fan, self-diagnosis and follow me are functions available with your Klimaire Unit..
  • DC Inverter technology extends the heating and cooling capacity at lower ambient conditions down to 5 F/-15 C and provides up to 30-Percent power savings..
  • Refrigerant Leak Detection monitoring (RLD) gives the ability to alert and prevent damages to Compressor and other vital parts of the system.MUST BE INSTALLED BY AN HVAC TECHNICIAN TO ENSURE PROPER INSTALLATION..
Check Stock

3-Zone (12K BTU + 12K BTU + 12K BTU) Klimaire 20 SEER Ductless Multi-Zone Inverter Air Conditioner Heat Pump with 16 Ft Installation Kits

  • Klimaire ultra high efficient 3-Zone 20 SEER ductless mini-split inverter system includes 3 indoor units, an outdoor unit, remote control, and 3 - 15 ft. Installation kits (Up to 2 Free 25-ft installation kit upgrade). Each indoor cools and heats an Area up to 550 sq. Ft.
  • Outdoor Unit is pre-charged and accommodates up to 25 ft length of refrigerant lines. Double cam twin rotary compressor and built-in compressor heater ensures the compressor longevity and reliability..
  • 4 in 1 system: heating, cooling, fan and dehumidification modes. Turbo function, multi-speed fan, self-diagnosis and follow me are functions available with your Klimaire Unit..
  • DC Inverter technology extends the heating and cooling capacity at lower ambient conditions down to 5 F/-15 C and provides up to 30-Percent power savings..
  • Refrigerant Leak Detection monitoring (RLD) gives the ability to alert and prevent damages to Compressor and other vital parts of the system.MUST BE INSTALLED BY AN HVAC TECHNICIAN TO ENSURE PROPER INSTALLATION..
Check Stock

GEARWRENCH 8 Pc. Sensor and Sending Socket Set - 41720

  • Designed for the removal and installation of oxygen sensors, oil pressure sending units, and vacuum switches.
  • Includes 3/8" drive 7/8" slotted socket for PVS, TVS and O2 sending units.
  • Includes 3/8" Drive 7/8" (22mm) socket for Oxygen Sensor Units.
  • Includes 3/8" Drive 1-1/16" Deep socket for Oil Pressure Sending units.
  • Includes 3/8" Drive 7/8" (22mm) Low Profile Offset socket for O2 Sensor Unit.
  • Includes 1/2" Drive 1-13/16" socket for Oil Sending Unit.
  • Includes 1/2" Drive 1-1/16" socket for Thermal Sensor units.
  • Durable blow mold case for safe storage and tool retention.
Check Stock

2\ Vacuum Pressure Gauge for Air Compressor Water Oil Gas 1/4\ NPT Lower Mount

  • Vacuum gauge with ultra-fine resolution (Resolution: 0.01 (.
  • Backlit, LCD digital display of 4 international units including Pa, mBar, mmhg, Microns, and a 1/2-second response time..
  • Connector type : Standard 7/16-20UNF Interface..
  • Supports four vacuum units, overrange protection and zero setting..
  • Measurement Accuracy: 2-100Pa (Digits ± 5%),Operating Temperature: 0-50°C(32-122).
Check Stock

Dixell XR60CX-5N1C1 Digital Thermostat Controller with Defrost Compressor Control of Evaporator Fans 230V/50-60Hz Programmable-Commercial for Refrigeration

  • The regulation is performed according to the temperature measured by the thermostat probe with a positive differential from the set point: if the temperature increases and reaches set point plus differential the compressor is started and then turned off when the temperature reaches the set point value again.In case of fault in the thermostat probe the start and stop of the compressor are timed through parameters COn and COF..
  • Two defrost modes are available through the tdF parameter:defrost through electrical heater (tdF= EL) and hot gas defrost (tdF = in).Other parameters are used to control the interval between defrost cycles (IdF), its maximum length (MdF) and two defrost modes: timed or controlled by the evaporator?s probe (P2P).At the end of defrost dripping time is started, its length is set in the FSt parameter. With FSt =0 the dripping time is disabled..
  • Forced activation of fans This function managed by the Fct parameter is designed to avoid short cycles of fans, that could happen when the controller is switched on or after a defrost, when the room air warms the evaporator. Functioning: if the difference of temperature between the evaporator and the room probes is more than the value of the Fct parameter, the fans are switched on. With Fct=0 t....
Check Stock