Bingfu SMA Male to UHF SO239 Female & PL259 Male RG58 Coaxial Jumper Cable 12 inch 30cm (2-Pack) for Portable VNA Vector Network Analyzer Antenna Analyzer Spectrum Analyzer SWR Meter Tester

  • Compatible with: Antenna Adapter Cable for Ham Radio, Amateur Radio, Handheld Floating Marine VHF Radio, Two Way Radio, Walkie Talkie, USB RTL SDR Receiver.
  • Compatible with: Test Probe Coaxial Jumper Cable for Handheld RF Explorer, SWR Meter, VNA Vector Network Analyzer, Antenna Analyzer, Spectrum Analyzer.
  • Package List: 2 x Cable (As the Picture Shown).
Check Stock

USB Logic Analyzer Device with USB Cable 5MHz 24MHz 8CH 8 Channel UART IIC SPI Debug Logic Analyzer Professional Microcontroller Device Network Analyzing Set for Ardu-ino FPGA ARM M100 SCM

  • Logic analyzer is a waveform test device similar to an oscilloscope. It collects specified signals and displays them to developers through graphics or data statistics. Developers use these graphical timing signals to analyze hardware or software errors in accordance with the protocol..
  • Logic analyzer is an indispensable device in design. It can quickly locate errors, find and solve problems, especially when analyzing timing, such as 1wire, I2C, UART, SPI, CAN and other data, the application of logic analyzer to solve problems is very fast..
  • Plug the DuPont cables into the logic analyzer interface one by one. After the DuPont cables are inserted, they will be divided into 2 rows. The upper row of 5 logic analyzers corresponds to the silk screen on the left side of the shell, and the bottom one row corresponds to the silk screen on the right. Before testing the signal, please connect the GND channel of the logic analyzer to the GND pin of the board, otherwise the measured data will be unreliable..
  • If the logic analyzer works at 24M, the USB device must not only provide a 24M communication rate, but also must ensure that other devices occupy USB resources before the 4 buffers are filled. For these reasons, the logic analyzer cannot always work at the sampl....
Check Stock

Bingfu Ham Radio Antenna Adapter SMA Male to UHF SO239 Female RG58 Coaxial Jumper Cable 1m 3 feet for Two Way Radio Handheld Marine VHF Radio RTL SDR Receiver Portable VNA Vector Network Analyzer

  • Connector: UHF SO239 Female 50 Ohm Connector.
  • Compatible with: Antenna Adapter Cable for Ham Radio, Amateur Radio, Handheld Floating Marine VHF Radio, Two Way Radio, Walkie Talkie, USB RTL SDR Receiver.
  • Compatible with: Test Probe Coaxial Jumper Cable for Handheld RF Explorer, SWR Meter, VNA Vector Network Analyzer, Antenna Analyzer, Spectrum Analyzer.
  • Package List: 1 x Cable (As the Picture Shown).
Check Stock

[2022 Upgraded] AURSINC NanoVNA-H4 V4.3 Vector Network Analyzer 10KHz-1.5GHz HF VHF UHF 4'' Portable Antenna Analyzer Measuring S Parameters, Voltage Standing Wave Ratio, Phase, Delay, Smith Chart

  • ✔️[2022 Upgraded Nanovna-H4 HW V4.3 ] Latest features: with latest HW 4.3 version, Nanovna-H4 is added a brand new panel plus added a new SD port for data storage(support up to 32GB memory card, not included in the package). The NanoVNA-H4 vector network analyzer is a Hugen Origin that provides perfect vector network measurement capabilities, tiny and handheld, stand-alone with 4-inch LCD display, portable with 1950mAh battery powered or USB powered.
  • ✔️[Improved Frequency Algorithm] The improved frequency algorithm of NanoVNA-H4 can use the odd harmonic extension of si5351 to support the measurement frequency up to 1.5GHz. The 50K-300MHz frequency range of the si5351 direct output provides better than 70dB dynamic, The extended 300M-900MHz band provides better than 60dB of dynamics, and the 900M-1.5GHz band is better than 40dB of dynamics.
  • The metal shield is designed to reduce the external interference and improve the measurement accuracy.
  • ✔️[Antenna Performance Measurement] The default firmware main function for NanoVNA-H4 vector network analyzer is used for antenna performance measurement. The TX/RX method can measure the complete S11 and S21 parameters. If you need to obtain S12 and S22, you need to manually replace the transceiver port ....
Check Stock

3.12 Inch Spectrum Analyzers OLED Music Spectrum Display Analyzer Audio Level Indicator VU Meter 1P

  • 3.12 inch OLED music spectrum display analyzer audio level indicator VU METER 1P. Support 8 kinds of display effects (key switch), support time display, temperature and humidity detection..
  • Spectrum range: full audio range (20HZ~20KHZ).High and low temperature resistance, more suitable for vehicles..
  • Advantages of OLED screen: Low power consumption, high brightness.
  • Compared with ordinary LCD screens, OLED has a faster response speed.
  • OLED is more resistant to vibration than VFD (vacuum screen).
  • No music input automatically switches to the time display function..
  • Built-in high-sensitivity microphone, no longer worry about wiring.
  • It also supports audio line input, it is recommended to use audio line input to obtain more accurate spectrum effects..
Check Stock

2pcs USB Logic Analyzer Device with USB Cable 24MHz 8CH 24MHz 8 Channel UART IIC SPI Debug for Arduino ARM FPGA M100 SCM

  • ✹✹The logic for each channel sampling rate of 24M/s. General applications around 10M, enough to cope with a variety ofoccasions..
  • ✹✹Sampling rate up to: 24 MHz , can be 24MHz. 16MHz, 12MHz, 8MHz, 4MHz, 2MHz, 1MHz, 500KHz, 250KHz, 200KHz, 100KHz, 50KHz, 25KHz.
  • ✹✹Input voltage range: -0.5V to 5.25V.
  • ✹✹ART, SPI, IIC and other communication debugging, let you get twice the result with half the effort. 24M sampling rate, can automatically analyze UART, IIC, SPI and many other standard protocols..
  • ✹✹his item is an inexpensive logic analyzer designed to be compatible with Saleae Logic Analyzer software, but this item is not an official Saleae product. This item is also supported by the free software by Sigrok called PulseView..
Check Stock

Comidox 1Set USB Logic Analyzer Device Set USB Cable 24MHz 8CH 24MHz 8 Channel UART IIC SPI Debug for Arduino ARM FPGA M100 Hot

  • This item is an inexpensive logic analyzer designed to be compatible with Saleae Logic Analyzer software, but this item is not an official Saleae product. This item is also supported by the free software by Sigrok called PulseView..
  • Sampling rate up to: 24 MHz , can be 24MHz. 16MHz, 12MHz, 8MHz, 4MHz, 2MHz, 1MHz, 500KHz, 250KHz, 200KHz, 100KHz, 50KHz, 25KHz..
  • The logic for each channel sampling rate of 24M/s. General applications around 10M, enough to cope with a variety ofoccasions..
  • A total of 8 digital channels, the voltage range is 0V and 5.5V, of which 1.5V is the voltage threshold, below 1.5V is considered low, above 1.5V is considered high..
  • UART, SPI, IIC and other communication debugging, let you get twice the result with half the effort. 24M sampling rate, can automatically analyze UART, IIC, SPI and many other standard protocols..
Check Stock

FrSky Taranis X9DP 2019 Access/ACCST D16 Transmitters 24 Channels with a High-Speed Module Gigital Interface (Ash White)

  • With the new spectrum analysis function added to the OpenTX firmware, it is now possible to check the airwaves for RF noise..
  • Communication ProtocolACCST D16 /ACCESS Feel Free to Choose.
  • Haptic vibration alerts and voice speech outputs.
  • Supports spectrum analyzer function Supports SWR indicator warning.
Check Stock

IS Icstation 12X11 Color LED Music Audio Spectrum Analyzer Level Indicator Kit with Case DIY Electoronics Soldering Practice Set

  • DIY 12X11 color LED frequency spectrum analyzer projects assemble kit.
  • 5mm diameter red blue and green color LED diode simulate audio spectrum with acrylic case and supporting audio and microphone input.
  • Comes with acylic light filter plate case to cover the mainboard to make it more beautiful after assembled.
  • Working Voltage:5V,PCB Size:119X118.5mm/4.69X4.67inch(L*W).
  • Ship it out by USPS with tracking information and 7-17 days delievery time usually.
Check Stock