NDS Square Catch Basin Drain Downspout Grate, 12 in., Black Plastic

  • Protect your drainage system by deflecting leaves, needles, twigs, nuts, and seeds that travel from overhanging trees to your rooftop into your downspout, while capturing excess surface water into your catch basin or low-profile adapter. Use with the 12 in. square catch basin, riser, or low-profile adapter to drain excess stormwater from under downspouts.
  • Fits on 12 in. Square Catch Basin Drain, 12 in. Riser, and 12 in. Low-Profile Adapter. 167 GPM flow rate. 54.5 sq. in. of open surface area.
  • Receives downspouts from 2 in. to 6 in. round or square.
  • Lightweight and easy to install. Reduces downspout splashing to protect your property walls.
  • Unique design captures more water than traditional flat drain grates or drain covers. Angled grate allows debris to slide off the surface and away from the drain into tray.
  • Comes with one 12 in. Square Catch Basin Drain Downspout Grate. Hassle-free limited lifetime warranty guarantees the NDS product is free from defects—or we’ll replace it.
Check Stock

CELLPOWER CPUSB01 12V to 5V MiniUSB Power Adapter with BDP (Battery Discharge Prevention) Low Voltage Cut-Off for Street Guardian SG9665GC (and Other Mini-USB Powered) DashCam Products

  • CELLPOWER CPUSB01 12V to 5V MiniUSB Power Adapter with BDP (Battery Discharge Prevention) Low Voltage Cut-Off for Street Guardian SG9665GC (and other mini-USB powered) DashCam products.
  • Please search for SGDCHW for use with SG9663DC. Hard wire power directly to your DashCam (miniUSB powered) 12-24 Volt Compatible..
  • You can wire the CELLPOWER CPUSB01 miniUSB BDP hard wire kit to a “Switched” Accessory fuse power circuit and it will turn on/off with the car engine. Tip: Be sure to actually start the engine when testing Switched ACC power, turning the key one notch to ACC without starting the engine is too low on some cars.
  • You can technically wire it to “Non-Switched” Battery fuse power circuit, but we recommend the Vico-Power Plus or MotoPark Fine Safer for parking mode operations.
  • Total Length = 13 feet / (4 meters) miniUSB side = 8 feet / (2.5 meters) fuse panel side wire = 5ft (1.5 meters) Red/Black wires are 16 AWG *Note, Add-a-fuse pigtail not included (5A fuse is ok).
Check Stock

NDS 1212 Square Catch Basin Drain Grate, 12 in, Green

  • Protect your drainage system by blocking leaves and debris from entering and potentially clogging the pipeline while letting excess surface water flow through. Use with the 12 in. catch basin, riser, or low-profile adapter to drain heavy flows of excess stormwater from lawns, landscaped areas, under downspouts, patios, and walkways.
  • Fits 12 in. Catch Basin storm drain, 12 in. Riser, and 12 in Low-Profile Adapter. 162 GPM flow rate. 53.1 sq. in. of open surface area. Rated for NDS Class B loads (up to 175 psi) when properly installed—recommended for medium-duty pneumatic tire traffic, autos, and light trucks at speeds less than 20 mph.
  • cover fits on catch basins, risers, and low-profile adapters and can be secured with screws. 12 in. Catch Basin Drain Grates are available in a variety of colors, materials, and styles.
  • Made to fit 12 in. square catch basins, risers, and low-profile adapters.
  • Comes with one 12 in. Square Catch Basin Drain Grate. Hassle-free limited lifetime warranty guarantees the NDS product is free from defects—or we’ll replace it.
Check Stock

NDS 1215 Square Catch Basin Drain Grate, 12 in, Galvanized Steel

  • Rust- and corrosion-resistant galvanized steel grate protects your drainage system by blocking leaves and debris before they can enter and clog your pipeline. Use with the 12 in. catch basin, riser, or low-profile adapter to drain heavy flows of excess stormwater from driveways, parking lots, and landscaped areas.
  • Fits 12 in. Catch Basin storm drain, 12 in. Riser, and 12 in. Low-Profile Adapter. 348 GPM flow rate. 113.8 sq. in. of open surface area. Rated for NDS Class C (H-20) loads (up to 325 psi) when properly installed—recommended for heavy-duty pneumatic tire forklifts and tractor-trailers at speeds less than 20 mph.
  • fits on 12 in. catch basins, risers, and low-profile adapters, and can be secured with screws. 12 in. Catch Basin Drain Grates are available in a variety of colors, materials, and styles.
  • Made to fit 12 in. square catch basins, risers, and low-profile adapters.
  • Comes with one 12 in. Square Catch Basin Drain Grate. Hassle-free limited lifetime warranty guarantees the NDS product is free from defects—or we’ll replace it.
Check Stock

30PCS Jcase Fuse Assortment Automotive Low Profile Box Shaped Mini Jcase Fuse Kit - 20A 30A 40A 50A 60A for Pickup Trucks, Cars and SUVs

  • Includes 30 LOW PROFILE fuses, 6 fuses of each amp rating: 20, 30, 40, 50, and 60 amperes..
  • Use Standard Fuse Assortment Kit as your automotive wiring and electrical safety equipment, protects your vehicle and electrical devices from a short circuit or overload..
  • When you buy before, please check the fuse set model is suitable for your car..
  • An incredible value! Far less expensive than factory replacements!.
Check Stock

Electric Fan Wiring Kit Electric Fan Relay Kit with Thermostat Radiator Fan Sensor Switch Electric Cooling Fan Thermostat Kit Temperature Sensor Switch 185 On 175 Off, 40 AMP Waterproof Relay Kit

  • Easy to follow wiring diagram simplify wiring your electric fans. RED to 12VDC positive battery terminal, COFFEE to Fan Positive, BLACK to Ignition, GREY to Sending Unit per wiring diagram. Direct replacement part fits 10, 12, 14, and 16 inch cooling fans. For dual fan wiring, you would need two of this relay kit.
  • Temperature switch turns on fan approximately at 185 Degrees and Off at 175 Degrees. The temp sensor has a 3/8 inch pipe thread, and a 1/2 inch adapter included.
  • This electric cooling fan thermostat kit comes with everything you need, includes 40A waterproof relay, wiring harness, temperature switch, 3/8 inch to 1/2 inch adapter, inline fuse holder, 20 amp fuse, 4 ring terminals and 2 fan pigtail connectors.
  • The thermostat supplied with this kit is OE style to mount in the cylinder head of the engine or any water jacket if needed.
  • If you intend to mount high-profile fans, you could crimp or solder bigger wires to it. The 14AWG wires (15 amps) are not bigger enough for high amps draw.
Check Stock

CrocSee 30 Pieces Car Fuses Assortment Kit Tall/Standard and Low Profile Box Shaped Automotive Fuses for Ford Chevy/GM Chrysler/Dodge and Toyota Pickup Trucks Cars and SUVs

  • Each fuse is clearly marked with amperage and color coded for easy identification.
  • Available in 20-60 amps, the cartridge fuse is to meet a wide variety of applications.
  • Includes both standard size (rated at 32 VDC) & low profile size (rated at 58 VDC).
  • Provides time delay and low voltage drop protection, perfect for RV, Trucks, Cars and SUVs.
  • Well packaged in a sturdy plastic box, keeps the fuses organized and easy to find.
Check Stock

TRENDnet 10/100Mbps PC Card TE100-PCBUSR

  • SEAMLESS TRANSFERS: Conveniently download music, videos, and pictures from a wireless internet connection, and then transfer those same files seamlessly to your Bluetooth enabled phone..
  • EASY SETUP: Get up and running with this bluetooth 5.2 PCIe Adapter in minutes with this intuitive guided setup.
  • WIFI 6 + BLUETOOTH 5.2 CLASS 2: This combination PCIe adapter simultaneously provides users with both WiFi AX and Bluetooth 5.2 connections, allowing you to concurrently connect to a WiFi network and Bluetooth devices. This PCIe adapter upgrades a standard or low-profile Windows computer to Wireless AX3000 & Bluetooth 5.2 (Class 2).
  • WIFI AX3000: Connect to an extreme performance 2401 Mbps Wireless AX or 600 Mbps Wireless N network with this adapter..
  • WIRELESS ENCRYPTION: Supports the latest WPA3 WiFi encryption.
  • SUPPORTING OPERATING SYSTEMS: Compatible with Windows operating systems.
  • PC BRACKETS INCLUDED: Includes standard and low-profile brackets.
Check Stock

ZOZOMOTORS Dual Electric Fan Relay Kit Radiator Electric Fan Thermostat Kit Temperature Sensor Switch 185 On 175 Off, Automotive 40 AMP Cooling Fan Relay Switch Kit 4 Pin, Dual Electric Fan Wiring Kit

  • Easy to follow wiring diagram simplify wiring your dual electric fans. RED to 12VDC Positive Battery Terminal, COFFEE to Fan Positive, BLACK to Ignition, GREY to Sending Unit per wiring diagram. Direct replacement part fits 10, 12, 14, and 16 inch cooling fans.
  • Temperature switch turns on fan approximately at 185 Degrees and Off at 175 Degrees. The temp sensor has a 3/8 inch pipe thread, and a 1/2 inch adapter included.
  • This electric cooling fan thermostat kit comes with everything you need, includes 40A relay, wiring harness, thermostat switch, 3/8 inch to 1/2 inch adapter, inline fuse holder, 2 20amp fuse, 1 spade connector for the temp sensor, 8 ring terminals, and 4 wire connectors.
  • The thermostat supplied with this kit is OE style to mount in the cylinder head of the engine or any water jacket if needed. The thermostat MUST be grounded through the threads to the engine in order for it to work, and the engine MUST be grounded.
  • If you intend to mount high-profile fans, you could crimp or solder bigger wires to it. The 14AWG wires (15 amps) are not bigger enough for high amps draw.
Check Stock