Reviews Ip Receiver Module

Low Noise Water Pump, Waterproof Plug and Play Water Pump with Motor, 370 Water Cooling Pump, Durable for RC Boat RC Aircraft Carriers DIY RC Boat RC Warships

The power supply method is not to take power from the receiver, battery used is greater than 2S and the voltage is between 7‑28V, need to use a step‑down module to make the operation more stable..
Suitable for installation on remote control boats that require water cooling with water‑cooled motors and without water‑absorbing steering gear.
Put it to work normally, the temperature will be hot, but it belongs to the normal range and will not affect the use..
Under the condition of 5V voltage, the pump works continuously for 15 hours and pumps water continuously..
It is waterproof and works well in water, JR plug suitable for plug into the receiver, plug and play..

2MP 1080P POE IP board Camera network Security camera module 2.8mm,3.6mm & 6mm fixed lenses Hidden Camera Indoor Security Surveillance Motion Detection for DIY/repair/upgrade.
Advanced H.265X/H.264 video compression,Super low rate,high definition quality of image.
Support various mobile monitoring(iPhone,Android).
Support POE IEEE8023af/at, And it's with additional assisted power supply. Power supply required: 12V 2A or above 2A.
Package content: 1 piece of POE mini IP board camera/network camera module..

The Happymodel 2.4GHz ELRS nano series receiver is an open source program based on ExpressLRS, we have 3 types rx module released..
On the basis of PP RX, we have developed the Nano 2.4GHz rx of ESP8285 version named EP1 and EP2. The RF module of EP1/EP2 is the same like PP RX and....
Due to the low-latency and high-refresh-rate RF module, they are very comfortable for FPV race and Long Range FPV. And very suitable for Tiny whoop....

This ir transmitter sensor module is directly launched by a single tube, it requires waveform modulation through the program..
It is suitable for infrared communication, infrared remote control, apply to a variety of platforms including for Arduino/51/AVR/ARM.
With signal indicating LED, easy to observe and debug..
Pin Definitions: (1) Output (2) Vcc (3) GND.
IR Infrared Transmitter Module Ir Digital 38khz Infrared Receiver Sensor Module For Arduino Electronic Building Block.

ADK (DIY Soldering Kit) for EverSet ES100 WWVB-BPSK Atomic Clock Receiver IC.
Hardware is compatible with Arduino - Atmega328P with Arduino Bootloader.
Includes all Parts to build the kit as shown in the Pictures - including 1x ES100-MOD Receiver Module and 1x ES100-MOD Carrier Board.
For Demo Program, Libraries, Documentation etc. see Manufacturer's Website.

...otor (5V) -Motor driver module for stepper motor ULN2003.
5V Active Buzzer -5V Passive Buzzer -LCD 1602 16 characters * 2 lines -LED Display Driver MAX7219 -LED Matrix Display of 8*8 -7 Segments Display 1 digit -7 Segments Display 4 digits -Simple Relay Module - Infrared Remote Control 38kHz - 38kHz Infrared decoder receiver (type 1838) - Infrared phototransistor (Flame sensor) - Infrared LED - Light sensor (Photoresistor).
-10 * LEDs 5mm Diffused RED -10 * LEDs 5mm Diffused GREEN -10 * LEDs 5mm Diffused YELLOW -5 * LEDs 5mm Ultrabright WHITE diffused -3 * LEDs 5mm Red / Green / Blue Diffused RGB -Shift Register (Series to Parallel IC) 74HC595 - NPN Transistor BC547 - PNP Transistor BC557 - Adjustable Knob Resistor 1kOhm (Potentiometer) - Adjustable Knob Resistor 10kOhm (Potentiometer).
- Resistor Pack 1/4W 1% accuracy, with 10pz of each value: 100, 220, 330, 470, 1K, 2K2, 4k7, 10K, 22K, 47K, 100K, 220K, 1M - 40-pin header 2.54 mm -40-pin header at right angle 2.54mm -5 * Capacitors for bypass tantalum 0.1uF -5 * Jumpers for header.

WiFi & ZWAVE Compatible (SOLD SEPARATELY - NOT INCLUDED).
L5210 All-In-One Home and Business Control System.
Integrated Z-Wave Support via L5100-ZWAVE Z-Wave Control Module for L5210 (SOLD SEPARATELY - NOT INCLUDED) Up to three thermostats (HVAC system or battery powered) with 1°F and 0.5°C set points Four door locks – Jammed locks reported to Honeywell Total Connect Remote Services 40 devices such as lights, switches and lamp modules 20 scenes 20 rules or event-based actions 20 schedules or time-based actions Sunrise/sunset lighting control Randomized lighting control.
Wi-Fi via L5100-WIFI Wi-Fi IP Communication Module for L5210 (SOLD SEPARATELY - NOT INCLUDED) IEEE 802.11 B/G/N radio Supports alarm reporting Supports two-way voice LYNX Connect app supports up to four mobile iOS and Android devices.
Honeywell 3GL Communications GSM radio (SOLD SEPARATELY - NOT INCLUDED) – protocol supports AT&T and Rogers networks ADEMCO Contact ID Reporting (four or ten digit account numbers) SIA Format Reporting Internet central station communication with L5100-WIFI or ILP5 module GSM cellular central station communication with internal GSM radio Selection for primary communication path when using dual paths Touch activated radio registration GSM....