Reviews Inductive Position Sensors

Fisher Labs Gemini-3 Metal Detector, Red, (GEMINI3)

Integral hanging loop and separate reservoir facilitates attachment in vertical applications.
3A no/NC dry contacts rated at 5A inductive at 230V ac at 5A inductive at 230V ac.

.../Relearn TPMS Sensors】To turn off the TPMS warning light after replacement, you need to relearn the sensors! Autel TS508 TPMS Reset Tool can wirelessly activate & relearn all OE or aftermarket TPMS sensors. TS508 can retrieve TPMS sensor data like Sensor ID, Tire Pressure, Tire Temperature, Sensor Battery, Sensor Position, Frequency, etc and provides you with 3 ways of on-tool relearn procedures: 1. Stationary Relearn. 2. Automatic Relearn. 3. Relearn by OBD (not included in TS508)..
【Program Autel MX-Sensors】Autel TS508 TPMS Programming Tool allows both DIYers and auto technicians to program sensor data to Autel MX-sensors(315/433MHz) in no time! TS508 comes with 4 TPMS sensor programming options: 1. Copy By Activation, 2. Copy By Manual Input, 3. Auto Create, 4. Copy by OBD( Not included in TS408) to replace faulty sensors with low battery life or not functioning well. NOTE: TS508 can program Autel MX-sensors only. It can NOT program other brand sensors..
【TPMS Reset/Diagnosis】Autel MaxiTPMS TS508 TPMS Service Tool is a new generation TPMS diagnostic and service tool that can read TPMS sensor status, check TPMS system health condition, diagnose the TPMS system to read and clear TPMS fault codes, relearn the sensors to the TPM ECU and reset ....

AUTOMATE YOUR HOME/OFFICE: The timer allows you to turn on and off your air conditioners, water heaters, pumps, signs, lamps, fans and other appliances automatically during a 24-hour cycle and once programmed, the settings will repeat daily.
SIMPLE TO USE: Pull all the tabs up to define the OFF state duration, push all the tabs down to define the ON state duration. Rotate dial clockwise to set time, aligning desired time with arrow. Set slide switch to the center position to run programmed setting.
CONVENIENT SCHEDULING AND FEATURES: The timer features multiple on/off setting and is designed with captive tabs, allowing for as little as 15-minute time intervals. The timer features automatic voltage detection and a real time clock face.
COMPATIBILITY: The timer is compatible with incandescent, compact fluorescent and LED light bulbs.
RATINGS: 120-277-Volt, 60 Hz, 40-Amp, 28-Volt DC, 20-Amp Resistive, 30-Amp Inductive/120-Volt, 30-Amp, 277-Volt, 20-Amp Ballast/120-Volt, 15-Amp Tungsten. Pilot Duty: 120VAC 720VA, 240VAC 720VA.

It's a nice little raspberry hat to easily connect I2C devices to your project..
Allows the use of daisy chain boards with different addresses, you can stack as many sensors as needed to create inductive power towers.
Uses 1mm pitch, 4-pin JST connectors, reducing the PCB space required, making installation easy and getting your project up and running in no time..
Pi hat has 4 connection ports, all on the same I2C bus, and the pins are marked ，once the hat is plugged in, you can start to insert the sensor.
This hat is compatible with any raspberry pi that uses standard 2x20GPIO connectors. It is designed to be installed on the side of the pi so that it can be easily used with the pi tin shell..

【Support Vehicles】*Sensors must be original OEM sensor.* TPMS19 TPMS Training tool works with 2006-2022 Ford, Lincoln,Mazda,Mercury.Please see the specific models supported at the third image..
【Easy to Use】With our TPMS19 Reset tool, you can reset your TPMS in 1 min. Just need 2 steps:1.Set your vehicle to TPMS learning mode. 2.Reset sensors.The order of resetting: Front left, front right, rear right, rear left. Press & hold power button. Once the speaker chirped, move to the next tire..
【Replacement for P/N】8C2Z1A203A, 8C2Z-1A203-A,TPMS19 for Car/SUV/Pickup/Light truck tire relearn tool..
【Tips】1.The sensors must be original OEM sensors which programmed well. 2.Front tire must be straight. 3. Do tire reset outside instead of in the garage and please make sure antenna fit in CORRECT position..
【Advantage】With portable mini design, you can reset the TPMS whenever you need. And we offer aftersale support, if you have questions about our product, feel free to contact us. We will answer you ASAP..

Product Name : Inductive Proximity Switch.
Wire Type : DC 3 Wire Type Brown, black, Blue).
Operating Temperature : -25C to +55C (Non-freezing Condition).
Size : 7 x 3cm/2.8'' x 1.2'' (L*Max. Dia).
Package Content : 1 x Inductive Proximity Switch Special note: if the product you received is damaged or does not work properly, please contact us by email in time, and we will replace the new product for you free of charge.