3\ Outside Air Kit for Pellet Stoves with 3\ Air Intake Pipe Including Harman Stoves 3\ X 10'

  • QuadraFire Thermocouple 800, 1000, 1100i, 1200, 1200i Pellet Stoves 812-0210.
  • Top Quality Aftermarket Replacement Part.
  • The Thermocouple is the device that monitors the fire after start-up. Once it reaches temp the thermocouple allows the stove to start feeding on it's own in normal operation mode. If your stove goes out after the initial start-up cycle, more than likely the thermocouple needs to be replaced..
  • Designed Specifically for the above mentioned models.
Check Stock

Montague OVEN THERMOCOUPLE 48\ 1036-7

  • K-type thermocouple connector with real chromel alumel contacts.
  • Miniature or mini k-type connector dimensions.
  • Works with all k-type thermocouple wires and extension wires.
  • Set of 10 male mini thermocouple connector plugs.
  • Compatible with thermocouple plugs from other manufacturers.
Check Stock

Emerson H06F 36 Universal Junction Block Thermocouple 36 inch

  • 36 inch junction block thermocouple with energy cut-off.
  • Stainless steel element construction for prolonged thermocouple life.
  • Standard coaxial thermocouple 11/32 inch double lead thread.
  • Universal adapter fittings included with each kit for replacing thermocouple in most types of pilot burners.
  • Works for both LP and natural gas applications.
Check Stock

Amprobe AM-510 Commercial/Residential Multimeter with Non-Contact Voltage Detection with a NIST-Traceable Calibration Certificate with Data

  • Safety: Rigorously tested to meet CAT IV 600V / CAT III 1000V.
  • listed by 3rd party safety labs CSA, ACMA, and has been assessed to meet high safety, health, and environmental protection requirements within the European Economic Area (EEA).
  • Key measurements and features: voltage up to 600Vac and 600Vdc, ac/dc current, 2 temperature inputs, duty cycle, peak hold (crest), low-pass filter, auto and manual ranging, resistance, microamps, diode testing, audible continuity, MIN/MAX recording, Data hold.
  • VolTect non-contact voltage detection, built-in flashlight and kickstand for safety and convenience, velcro strap to hang your meter, built-in test lead storage.
  • Dual thermocouple takes simultaneous temperature readings on low and high side of an HVAC system.
  • Relative zero mode displays the difference between the actual reading and a stored reference value and may be used with any function or range.
Check Stock

GBC Document Camera, Discovery 3000 (DCV10004)

  • pyrometer Temperature range: -50°C to 1300°C ( -58°F to 2372°F) and Overload display alert when input exceeds measurement range pyrometer. Thermocouple Temperature range: -50°C to 1000°C ( -58°F to 1832°F).
  • Designed for use with K-type thermocouples and Selection between Celsius and Fahrenheit.
  • Decimal or round number display selectable (decimal range is -58.0F to999.9F and round number range is -58F to 2372F).
  • Includes 2 Thermocouples ( One 3" K type temperature probe (-58 – 752 °F) and one Kiln Heavy duty K type Thermocouple ( -58°F to 1832°F) and Digital Pyrometer, 9V battery and Manual.
  • Thermocouple Measurement range: 32 - 1832 °F (0 - 1000 °C) Thermocouple Type: K Type Cable length : 3 ft Sensing tip length: 6" (150mm) Stainless Steel Sensing tip diameter: 0.19" (5mm) Thread width : 5/16" (M8) Internal Insulation: Fiber Glass External shielding: Metal Shield (Stainless steel braided).
Check Stock

Coolrunner Gas Patio Heater Repair Replacement Parts Outdoor Heaters Safety Kits Thermocouple (M8 x1) and FD4 Dump Switch for Propane Gas Patio Heater

  • Well Made & More Safe: The thermocouple is made of brass and red copper and the anti-tilt switch, made of ABS, which will automatically stop heating when the gas heater is tilted..
  • Wide Compatibility: The patio heater thermocouple replacement is suitable for most of propane heater, patio heater and other gas heaters with thermoelectric safety..
  • Dimension: The total length of thermocouple is 350mm, thermocouple probe is M6*0.75 and threaded end is M8*1, please measure your original parts before ordering. Weak current FD4 dump switch is for gas R≤10 mΩ..
  • Easy to install: It is easy to replace just follow the way you remove the defective part. Notice: Keep the thermocoupler probe about 5mm from the burner hole..
  • Great Value for Money: If the thermocouple or dump switch of your gas heater is broken, you just need to change the replacement that will save $200 for you..
Check Stock

UNI-T UT701 Single Function Temperature Calibrator

  • 1. Up to 0.05% output accuracy 2. 6-digit display 3. Output functions: DC voltage, resistance, thermocouple, and thermal resistance.
  • 4. 10 thermocouple scales 5. 4 thermal resistance scales 6. High precision automatic cold junction compensation for thermocouple outputs.
  • 7. Manual stepping and automatic stepping and ramping 8. Stores and recalls setups.
Check Stock

Bakers Pride M1296X 72 Long T46 Thermocouple

  • K-type Thermocouple wire for making thermocouple or extension wire, up to 752 °F (400 °C).
  • Chromel / Alumel type K thermocouple wire with Standard Accuracy: +/- 2.2 °C or +/- .75%.
  • The K-type wires are AWG 24 (0.51 mm) in diameter.
  • ANSI color coded braided fiberglass insulation, red = -, yellow = +.
  • 10 yard ( 30 ft ) roll, wire is flexible and easy to bend to shape.
Check Stock

Thermocouple Probe Kit Compatible with Traeger Ironwood 650/885 and Pro 575/780, KIT0422

  • T-type thermocouple connector, real Copper / Contstantan contacts.
  • Miniature or mini T-type connector dimensions.
  • Works with all T-type thermocouple wires and extension wire.
  • 5 sets, each contains a male and a female connector (2 pieces).
  • Compatible with thermocouple plugs from other manufacturers.
Check Stock