Reviews High Input Common Mode Range

Texas Instruments LM358P Low Power Dual OP Amplifier, General Purpose, 8-Pin, -16-32 Volt, 9.81 mm L x 6.35 mm W x 4.57 mm H (Pack of 15)

Four independent voltage comparators that are designed to operate from a single power supply over a wide range of voltages.
Wide Supply Ranges Single Supply: 2 V to 36 V, Dual Supplies: ±1 V to ±18 V, Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage: ±36 V, Low Input Offset Current: 3 nA (Typical).
Low Supply-Current Drain Independent of Supply Voltage: 0.8 mA (Typical), Low Output Saturation Voltage, Common-Mode Input Voltage Range Includes Ground.
Low Input Bias Current: 25 nA (Typical), Low Input Offset Voltage: 2 mV (Typical), Low Output Saturation Voltage.
Example Applications: Industrial, Automotive: Infotainment and Clusters, Body Control Modules, Power Supervision, Oscillators, Peak Detectors, Logic, Voltage Translation.

...20: G=1+50K/Rg, AD623: G=1+100K/Rg ✭Maximum magnification of the module: more than 2000 times (actual measurement), due to the large gain of the waveform frequency band, it is recommended to use multi-stage amplification with high gain ✭Fixed output voltage: 5V-10V (default delivery 5V).
♥ Other parameters: ✭Common mode rejection ratio: AD620: 100dB (minimum, G=10).
AD623: 90dB (minimum, G=10) ✭Input bias current: AD620: 1.0nA (max).
AD623: 23nA (max) ✭Input offset voltage: AD620: 50μV (max).
AD623: 200μV (max) ✭Input offset offset: AD620: 0.6μV/°C (max).
AD623: 2μV/°C (max) ✭Input voltage noise: AD620: 9nV/√HZ (1KHZ).
♥Precautions: 1. The power supply of the module is a single power supply, and the voltage cannot exceed 26V 2. Since the module is a high-precision device, to avoid unnecessary interference, it is recommended to use a linear power supply for power supply 3. It is recommended to use SMA to BNC line input and output signal for the output signal. Compared with the observation effect, poor contact or inferior wire may cause signal attenuation or excessive noise..

The TL081CP JFET-input operational amplifier family is designed to offer a wider selection than any previously developed operational amplifier family. Each of these JFET-input operational amplifiers incorporates well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit..
Equivalent Input Noise Voltage 3.5 nV/√Hz Typ and High Slew Rate 13 V/µs Typ, Unity-Gain Bandwidth 10 MHz Typ and Wide Supply-Voltage Range ±3 V to ±20 V.
Common-Mode Rejection Ratio 100 dB Typ and Low Harmonic Distortion.
High DC Voltage Gain 100 V/mV Typ and Offset Nulling Capability.
Peak-to-Peak Output Voltage Swing 32 V Typ With VCC± = ±18 V and RL = 600 Ω and External Compensation Capability.

The TL081CP JFET-input operational amplifier family is designed to offer a wider selection than any previously developed operational amplifier family. Each of these JFET-input operational amplifiers incorporates well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit..
Unity-Gain Bandwidth 10 MHz Typ and Wide Supply-Voltage Range ±3 V to ±20 V, Equivalent Input Noise Voltage 3.5 nV/√Hz Typ and High Slew Rate 13 V/µs Typ.
Common-Mode Rejection Ratio 100 dB Typ and Low Harmonic Distortion.
High DC Voltage Gain 100 V/mV Typ and Offset Nulling Capability.
Peak-to-Peak Output Voltage Swing 32 V Typ With VCC± = ±18 V and RL = 600 Ω and External Compensation Capability.

[2021 Upgraded Version: ESD Protection Diodes] Tinysa with latest firmware V0.3.1, the displayed version info is "ESD protected" meaning the diodes are installed which will be more stable and sensitive with higher antistatic level and longer service life. Spectrum Analyzer with two inputs, high quality MF/HF/VHF input for 0.1MHZ-350MHz, lesser quality UHF input for 240MHz-960MHz. Switchable resolution bandpass filters for both ranges between 2.6kHz and 640kHz.
[Frequency Range] Spectrum analyzers like the tinySA use a resolution filter that is used to isolate the input power in a small frequency range. This resolution filter is swept across the desired frequency range. The fastest scanning speed occurs with an RBW or 300kHz or wider and is about 2 scans per second. But with increase of the frequency span and decrease of the RBW the scanning speed decreases quickly. A scan from 0MHz to 350MHz with an RBW of 10kHz takes about 2 minutes..
[2 in 1 Device] When not used as Spectrum Analyzer it can be used as Signal Generator, MF/HF/VHF sinus output between 0.1MHZ-350MHz, UHF square wave output between 240MHz-960MHz. Built-in calibration signal generator that is used for automatic self test and low input calibration. The tinySA contains all the components of....

INA114 is a low-cost, high-precision instrumentation amplifier that only requires an external resistor to set the gain, and the gain range is 1 to 10000..
the weak signal detection effect is excellent, and can input single-ended signals or differential signals..
Chip features: Offset voltage 50uV, drift 0.25μV/℃, and high common mode suppression, 115dB when G=1000.
Module application: bridge amplifier, thermocouple amplifier, RTD sensor amplifier, medical equipment, data acquisition front end.

Your purchase includes One Samsung 50” 4K Smart LED TV, 2018 Model, One Remote TM1240A, One Power Cable, One User Manual.
TV dimensions: Without Stand – 44.3” W x 25.6” H x 2.4” D. With Stand – 44.3” W x 27.3” H x 9.5” D. Display size: 49.5″ Measured Diagonally, Resolution 3,840 x 2,160.
Stunning view, high-dynamic-range content with a TV designed to support HDR10+. Enjoy millions of shades of color, fine-tuned to create an incredibly vibrant picture.
Typical Power Consumption 60 | Maximum Power Consumption 125. TV does not support Bluetooth function.
Inputs & Outputs: HDMI 2 | USB 1 | Ethernet (LAN) Yes | RF In (Terrestrial/Cable Input) 1/1(Common Use for Terrestrial)/0 | RF In (Satellite Input) | 1/1(Common Use for Terrestrial)/0.

The NE5534 devices are high-performance operational amplifiers combining excellent dc and ac characteristics. Some of the features include very low noise, high output-drive capability, high unity-gain and maximum-output-swing bandwidths, low distortion, and high slew rate..
Unity-Gain Bandwidth 10 MHz Typ and Wide Supply-Voltage Range ±3 V to ±20 V, Equivalent Input Noise Voltage 3.5 nV/√Hz Typ and High Slew Rate 13 V/µs Typ.
Common-Mode Rejection Ratio 100 dB Typ and Low Harmonic Distortion.
High DC Voltage Gain 100 V/mV Typ and Offset Nulling Capability.
Peak-to-Peak Output Voltage Swing 32 V Typ With VCC± = ±18 V and RL = 600 Ω and External Compensation Capability.