Reviews Gpio Extension Board

HiLetgo 3pcs NodeMCU GPIO Board ESP8266 NodeMCU Pin Out IO Out 1 into 2 for ESP8266 ESP-12E NodeMCU Development Board

  • NodeMCU can be connected through by Pin Header & Screw Terminal.
Check Stock

KEYESTUDIO L298P Motor Driver HAT Shield GPIO for Raspberry Pi Model B/B+/A+/2/3/4 Zero and Zero W, High-Power Motor Speed Control Board Dual H Bridge with IR Receiver

  • This Motor Driver HAT gives your Raspberry Pi the ability to drive two DC motors, with drive current up to 2A..
  • Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards like Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+/4B and later versions.
  • Reserved I2C SPI control pins, allows to work with other control boards and sensors. Comes with an IR receiver for communication with an infrared remote controller..
  • Included 4x M2.5*20MM screws, 4 xM2.5*10MM copper pillars, 4x M2.5 Nuts. Easy to install on your RPi board. Please note Raspberry Pi board, remote control and motors in the photos are Not Included!.
Check Stock

UNIROI Raspberry Pi RAB Holder Breadboard Kit with 830 Points solderless Circuit Board Raspberry Pi Holder for Arduino, Mega 2560 & Raspberry Pi 4B, 3B+, 3B, 2B and 1B+, A+ (52 Items)

  • This 14 in 1 RAB Holder kit is designed by for the Raspberry Pi and Arduino hobbyists, the holder is large enough for a Raspberry Pi 4B/ 3B/ 2B/ 1B+/ Zero/ Zero W, Arduino 328P Control Board or Mega 2560, and a 400 hole or 830 hole Circuit Board breadboard.
  • Including RPi GPIO Breakout Expansion Board and Ribbon Cable, which are special for Raspberry Pi 3 Model B, 2 Model B, 1 Model B+ and zero/ zero W..
  • This 830-tie/point breadboard includes an IC area of 630 points, plus two 100-point distribution strips, providing 4 power rails..
  • Comes with male-to-male 65pcs jumper wires, red, green, and yellow LEDs (three for each color), ten 1k resistors, a screwdriver, and some screws..
  • Gift: GPIO 40 pin Table Card for wiring Pi and BCM codes for all RPI motherboard..
Check Stock

KEYESTUDIO Automatic Smart Plant Watering Kit for Arduino, Automatic Watering System for Your Plants

  • New Flexible Microcontroller Board --- Raspberry Pi Pico is a tiny, fast, and versatile board. It's based on RP2040 chip, which features a dual-core Arm Cortex-M0+ processor with 264KB internal RAM and support for up to 16MB of off-chip Flash, flexible clock running up to 133 MHz..
  • Multi-Function GPIO Pins---It has 26 multifunction GPIO pins, including 3 analogue inputs, 2 × UART, 2 × SPI controllers, 2 × I2C controllers, 16 × PWM channels..
  • Rich Peripheral Set---A wide range of flexible I/O options includes I2C, SPI, and — uniquely —8 × Programmable I/O (PIO) state machines for custom peripheral support..
  • Multiple Software Support---Raspberry Pi Pico has rich and complete software support and community resources. Programmable in C and MicroPython. Drag-and-drop programming using mass storage over USB..
  • This kit includes a Rpi Pico with headers soldered, 3-pin yellow header,830 breadboard, Doupont wires and micro USB cable..
Check Stock

Smraza Raspberry Pi 3 B+ Case with Fan, 5V 2.5A Power Supply and 3 Heat Sinks for Raspberry Pi 3 Model B+ (B Plus), 3B, 2B

  • ✓ The Latest Version 9 Layers case for Raspberry Pi 3 model B+ / Raspberry pi 3 /pi 3 model b / pi 2 / pi 2 b (Not include Pi Board).
  • ✓ Raspberry Pi Case has the layout design for the Raspberry pi 3 model b+ and will perfectly protect your pi components.
  • ✓ Easy to access all GPIO ports - Raspberry pi case with cutout to allow Pi's GPIO, HDMI, USB, SD, Power Supply and Other GPIO Ports access.
  • ✓ Made of Acrylic, the raspberry pi 3b case Won’t Block your raspberry pi's Wifi / Bluetooth Signal.
  • ✓5V 2.5A power supply with 59 Inch power cable is durable, on/off switch would cause less wear and tear on your raspberry pi's power port. Package Include: Raspberry Pi 3 B+ Case, Fan, 3 Pcs Heatsinks, 2.5A Power Supply.
Check Stock

Geniatech XPI-3288 Android Single Board Computer Development Board Moudle,Rockchip RK3288 Quad Core CPU 2G RAM, 16GB EMMC Flash Motherboard

  • Card-sized High Performance Board, Rockchip RK3288 with Quad-core Cortex-A17 up to 1.6GHz, 2G RAM, 16GB eMMc flash, faster read / write speeds for the OS, applications and file storage.
  • 4*USB2.0, 1*HDMI Out, 1*Micro USB, 1*UART, 1*GPIO interface, WiFi and 1000M LAN interface, Micro SD card (TF card : Max64G).
  • Multiple DIY use Single Board Computer, use the Form Factor of Raspberry Pi, DIY Friendly Design: 40 Pin GPIO header with I2S, I2C, SPI, UART, etc.
  • According to the definition of Raspberry Pi, which is suitable for the field of programming education for teenagers.
  • Compatibility and Extensibility: 40 Pin header enables hardware re-use by maintaining compatible alternate pin functions like I2S, I2C, SPI, UART, and so on.
Check Stock

Sonicon Emuson Emulation Board Replaces Raspberry Pi 3B+, Mini Computer w/ 148 Emulators Preloaded, RetroPie ROM Downloader for Arcade Cabinet Retro Gaming (8GB + 128GB)

  • World's 1st Emulation Board - Sonicon EmuSon Emulation Board is world's 1st single-board-computer made specially for emulation - an all in one solution for your retro gaming need..
  • Replace Raspberry Pi Perfectly - Emuson Board shares the same dimensions and interfaces with Raspberry Pi 3b+, and also has the standard 40-pin GPIO pinouts. It supports all the Raspberry Pi 3b+'s cases and most HAT and pHAT add-ons..
  • Just Right Hardware and Software - This low cost, low power consumption, quiet (no cooling fan needed) yet powerful mini computer is perfect for emulation. The OS and emulator software are installed on the board, plug it in and start enjoying the games..
  • EmuSon OS - A full fledged emulation OS pre-installed on the board, supports 70+ systems and 148 emulators, be it arcade, console or home computer, from 1st gen's Atari to 6th gen's Dreamcast, from Mame, FBNeo to Naomi. Auto save/load w/ snapshot, media-rich game lists, easy filtering and searching in vast game lists, screenshot and recording, AI translation for foreign games, supports major controllers out of the box..
Check Stock

Argon ONE M.2 Aluminum Case for Raspberry Pi 4 with Power Button and Fan | SATA SSD Support | B-Key and B+M Key Compatible

  • Most powerful Raspberry Pi 4 case with M.2 SATA SSD Carrier Board, Power Button, Controllable Internal 30mm Fan & IR Sensor.
  • Integrated with M.2 SATA Expansion Kit for use with M.2 SATA SSD B-Key or B+M Key.
  • power and transfer via USB 3.0 Port. With safe shutdown power button & software controllable 30mm fan..
  • Keeps RPI 4 cooler with aluminium case enclosure and heatsink. GPIO access via removable magnetic cover..
  • Neat cable management. Easily connect power cable, two (2) full sized HDMI display ports, GPIO accessories and comes with built-in IR..
  • Maximize Pi4 potential as a single board computer by turning it into a tiny desktop, media player, retro console or server. Compatible with Raspberry Pi 4 Model B 1GB / 2GB / 4GB / 8GB..
Check Stock

SparkFun MicroMod Artemis Processor - Modular Interface Ecosystem That Connects Artemis microcontroller/Processor Board to Various/Carrier Board peripherals

  • Artemis General Features: 1M Flash / 384k RAM, 48MHz / 96MHz turbo available, 6uA/MHz (operates less than 5mW at full operation), 48 GPIO - all interrupt capable, 31 PWM channels, Built in BLE radio and antenna.
  • Additional Artemis Features: 10 ADC channels with 14-bit precision with up to 2.67, million samples per second effective continuous, multi-slot sampling rate.
  • Additional Artemis Features: 2 channel differential ADC, 2 UARTs, 6 I2C buses, 6 SPI buses, 2/4/8-bit SPI bus, PDM interface, I2S Interface, Secure 'Smart Card' interface, FCC/IC/CE Certified (ID Number 2ASW8-ART3MIS).
  • Specific Peripherals made available on MicroMod Artemis: 1x USB dedicated for programming and debug, 1x UART with flow control, 2x I2C, 1x SPI, 1x Quad-SPI, 8x Fast GPIO, 2x Digital Pins, 2x Analog Pins, 2x PWM, 1x Differential ADC pair, Status LED, VIN Level ADC.
  • Additional peripherals are available but are shared on dedicated MicroMod pins. Processor board only, additional carrier board(s) will be needed to use..
Check Stock