Reviews Dc Immunity Current Transformers

12V 5A Power Supply for LED Strip Lights, 60W Power Adapter, 120V AC to 12V DC Transformer(1 set)

  • 12V Power Supply, DC 12 Volt 5Amps Output, 60 Watt Max Wattage.
  • Used for LED Strip Lights and 12V DC Devices (0.5A 1A 1.5A 2A 3A 4A 5A all are Suitable).
  • Commercial Grade AC to 12V DC Power Supply Adapter.
  • 12V Transformer New Upgraded Low Fever & No Noise, 1 Years Warranty.
  • Work for 12Vdc Devices at Max 5 Ampere 60Watt: RGB & Single Color 2835 3528 5050 5630 5730 DC12V Low Voltage Flexible LED Rope Strip Lights, LED Ribbon Tape Light, LED Modules, LED Cabinet Lamps, Under Counter Lighting, CCTV Cameras , Security Systems, the transformers Replacement for 12Volt LCD Monitors , 12Vac TVs, 12V Wireless Router , Hub, 12 Vac ADSL, LEDs Remote Controler and other 12 Vdc Lamp Devices or Generic Electronic items.
Check Stock

12V to 5V Direct Current Converter Buck Module USB Output Power Adapter Direct Current Power Adapter Converter Regulator Car Power Converter (3)

  • Parameter: these usb buck module input voltage range DC 12V and output voltage default DC 5V, the maximum output current is 3A, no-load current is 10mA and the maximum output power will reach 15W.
  • USB and high conversion: this DC to DC converter module has USB charging ports, DC to DC buck converter has integrated switch thin regulator module, the conversion rate is as high as 96%.
  • Intelligent protection: this 12V to 5V DC converter is using intelligent microprocessing chip, over voltage, over current, over temperature and short circuit, it can be auto protection.
  • Wide application: DC converter module 12V to 5V is widely applied for GPS navigation, driving recorder, electronic dog, car radio, MP3, MP4, walkie talkie, surveillance system, bus display, taxi advertising screen, LCD TV, LED, etc..
  • Warm prompt: the power of devices must be lower than 15W when using this DC to DC converter 12V to 5V, and not compatible with partial Samsung phones.
Check Stock

12v to 5v Converter Buck Module USB Output Power Adapter Dc Power Adapter Converter Direct Current to Direct Current Regulator Car Power Converter (1)

  • Parameter: these usb buck module input voltage range DC 12V and output voltage default DC 5V, the maximum output current is 3A, no-load current is 10mA and the maximum output power will reach 15W.
  • USB and high conversion: this DC to DC converter module has USB charging ports, DC to DC buck converter has integrated switch thin regulator module, the conversion rate is as high as 96%.
  • Intelligent protection: this 12V to 5V DC converter is using intelligent microprocessing chip, over voltage, over current, over temperature and short circuit, it can be auto protection.
  • Wide application: DC converter module 12V to 5V is widely applied for GPS navigation, driving recorder, electronic dog, car radio, MP3, MP4, walkie talkie, surveillance system, bus display, taxi advertising screen, LCD TV, LED, etc..
  • Warm prompt: the power of devices must be lower than 15W when using this DC to DC converter 12V to 5V, and not compatible with partial Samsung phones.
Check Stock

Current Transducer, SZT15-CH-420E Current Transducer Transmitter Transformer Sensor AC Current Converter 0-50A,Stable Performance

  • 【DC Current Output Signal】 - The SZT15-CH-420E AC current transducer provides real-time isolated measurement of AC current in the grid or circuit and converts it to a 0-5V / 0-10V or 4-20mA DC current output signal ..
  • 【Withstand Voltage】 - Through-heart structure design, insulation withstand voltage up to 2000V AC. The measured current AC: 0-10A / 20A / 50A can be selected..
  • 【Usage】 - Magnetic hysteresis less than 1%, can be used in strong magnetic field conditions. The current transducer is used for AC current monitoring, detection, current overload protection, and is also used as an electronic switch for automatic control systems..
  • 【High Performance】 - The outer casing is made of self-extinguishing material, it has the characteristics of strong overload ability, high precision, high isolation, high security, low power consumption and strong anti-interference ability..
  • 【Easy To Installation】 - There is no need to connect the dc series into the circuit during measurement, safe isolation of input and output. It is suitable for various applications requiring current and voltage conversion..
Check Stock

10-50V 100A 5000W DC Motor Engine Speed Controller 0-100% PWM Control Industrial Motor Speed Regulator for DC Brush Motor DC Lamps

  • PWM Duty Cycle:0%-100% and Quiescent current is 0.04A( not over 40mA when voltage is DC10V to DC30V).
  • Operating temperature:-20 to 40.It can perform normally when the temperature is below 0.
  • Universal speed controller can be used for DC brush motor, suitable for car cooling fan motor, car air conditioning motor, exhaust blower, treadmill motor, etc.
  • This motor speed controller can also be used for dimming DC lamps or controlling DC heater.
Check Stock

Hantek DSO2D10 2 CH Oscilloscope with Built-in DDS Generator, 100MHz 1GSa/s

  • ⚡【AC/DC amp clamp meter】 Hantek AC/DC Current amp Clamp probe with bnc for oscilloscope, 400Hz Bandwidth, 1mV/10mA, 650A..
  • ⚡【Multifunction】It is a transducer which allows your multimeter to measure current data and enable your oscilloscope to measure the current waveforms..
  • ⚡【BNC Probe】if connect to an oscilloscope by BNC type connector, you're able to observe the current waveforms..
  • ⚡【Application】1.Power circuit measurement and malfunction analysis.
  • 2.Motor drive of frequency converter (or other electronics) measurement.
  • 3.Power electronics equipments measurement..
  • ⚡【What you will get】1*AC/DC Current clamp CC-650,1*English Manual..
Check Stock

UCTRONICS DC 12V Time Delay Relay Module with Plastic Enclosure, On Delay and Off Delay for Automobile, Raspberry Pi, Industrial Control, and Other Electronic Projects

  • Max. Load Voltage: terminal NC is DC 30V or AC 250V, terminal NO is DC 28V or AC 125V.
  • Functions: Supports on delay and off delay modes, the delay time can be adjusted from 0.1s to 1h, the delay mode and delay time can be set by shorting or opening the jumper pins and rotating the potentiometer..
  • Self Protection: Built with protection against reversal diode, supports anti-reverse protection. NOTE: Please remove the jumper cap of S5 when controlling AC current or DC current voltages other than 12V, otherwise the module will be burned or will not work properly..
  • Applications: This module works as a switch with time delay on and off function, highly recommended for automotive circuit modification, and LED lights, DC motors, pump and smart home control system..
  • You'll Be Getting: A time delay relay module U6031, 2 pieces of protective case and 2 mounting screws.
  • the plastics case keep the module free from dust and water, which is available for more applications than the separate module..
Check Stock

2 Pieces DC Converter 12V to 5V 3A 15W DC Buck Converter Module, DC to DC Reduced Voltage Regulator Car Power Converter Output Power Adapter (Right Angle Type-C Interface)

  • 12V to 5V USB converter: input voltage: 12V DC.
  • Type-c and high conversion: this DC to DC power converters have right angle type-c charging ports.
  • Featuring an integrated switch thin regulator module, the conversion rate of this DC to DC buck converter is up to 96%.
  • Intelligent protection: 12V to 5V DC converter is using intelligent microprocessing chip, over voltage, over current, over temperature, short circuit, it can be auto protection.
  • Wide application: DC converter module 12V to 5V suitable for GPS navigation, driving recorder, electronic dog, car radio, car audio, MP3/MP4, walkie talkie, surveillance system, bus display, taxi advertising screen, driving recorder, LCD TV, LED, etc..
  • Warm prompt: those devices' power must be lower than 15W when use this DC/DC converter 12V to 5V, and not Compatible with partial Samsung phones.
Check Stock

Hantek 6254BE Digital oscilloscope 250MHz Bandwidth Automotive Oscilloscopes Car-Detector 4 Channels 1Gsa/s USB PC Osciloscopio

  • ⚡【AC/DC amp clamp meter】 Hantek AC/DC Current amp Clamp probe with bnc for oscilloscope, 20kHz Bandwidth, 1mV/10mA, 65A.
  • ⚡【Multifunction】It is a transducer which allows your multimeter to measure current data and enable your oscilloscope to measure the current waveforms..
  • ⚡【BNC Probe】if connect to an oscilloscope by BNC type connector, you're able to observe the current waveforms.
  • ⚡【Application】1.Power circuit measurement and malfunction analysis.
  • 2.Motor drive of frequency converter (or other electronics) measurement.
  • 3.Power electronics equipments measurement..
  • ⚡【What you will get】1*AC/DC Current clamp CC-65,1*English Manual..
Check Stock