Reviews Capacitor Discharge Pin

Goulds Pump J5S Shallow Well Jet Pump, 115/230 volt, 1/2 hp

Pumps are manufacturer tested and may contain water inside from such testing,.
See all sketch images for more details, NEMA standard, 60 Hz, 1/2 HP, 115/230 V capacitor start, single phase, 3500 RPM.
Built-in overload with automatic reset, stainless steel shaft, pressure regulator included..
Rotation: Clockwise when viewed from motor end, UL778 listed.
Pipe connections: 1. 25" Npt suction and 1" Npt discharge, pressure switch: as4 preset (30-50 PSI)..

1. Product size: 53x33x80 mm /2.1x1.3x3.31inch.
2.Connect Pin: 6.35x0.8 mm /0.25x0.03 inch (1/4 in Standard Terminal).
4.Terminals 2+2, each pole has 2 terminals, the capacitor has a built-in 10M Ohm resistor, which releases high voltage when idle or shut down to....
5.Completely compatible for Samsung 2501-001011 DE96-00269A and GE WB27X10011 and other same size capacitor for Amana Electrolux Ge Kenmore Whirlpool.

SEWAGE/EFFLUENT SYSTEM: contains 20"x30" basin, steel lid, sewage pump with float switch, PVC discharge piping and elbows, check valve, gromets, adaptors, and PVC elbows (assembly required).
LITTLE GIANT 9SC-CIA-RF SEWAGE PUMP INCLUDED: 115-Volt, 60 Hz, 4/10 HP continuous duty permanent split capacitor (PSC) motor.
AUTOMATIC OPERATION: equipped with a piggyback mechanical float switch.
actives when liquid reaches between 9 and 14 inches.
shuts off when liquid falls to between 2 and 6 inches.

See all sketch images for more details, NEMA standard.
60 Hz, 1/2 HP, 115/230 V capacitor start, Single phase, 3500 RPM.
Built-in overload with automatic reset, Stainless steel shaft, Pressure regulator included..
Rotation: clockwise when viewed from motor end, UL778 listed.
Pipe connections: 1.25" NPT suction and 1" NPT discharge, Pressure switch: AS4 preset (30-50 PSI)..
Note : All Pumps, Are Tested By The Manufacture, Prior To Shipping. At Times You Will Encounter A Smalll Amount Of Water Residue Left Over From The Test..

Perfect for Arduino mega sized base board and other programming boards.
Convenient for the prototypes and circuit design experiment and other DIY projects..
Used for electronic experiments and point-to-point DIY soldering projects, can be expandable with pin header and female header, designing your own Arduino kits..
Standard IC spacing 2.54MM hole plated through among the pad can be perfectly working with 3mm&5mm LED Diode kit, Electrolytic Capacitor kit, Monolithic Ceramic Capacitor kit, Resistor kit, etc..
Electroless Nickel Gold finished prevent the copper on PCB from being oxidized and corroded and is good for soldering and touching..
Made of glass fiber FR-4 material, features high heat resistance, corrosion resistance, mechanical strength, insulation..

THIS ITEM IS NOT AVAILABLE FOR SALE IN THE STATE OF CALIFORNIA! **.
Stainless steel 1.0 HP motor shaft is constructed with a reinforced thermoplastic body for longer life and durability, with carborundum and graphite mechanical seals and components.
INCLUDES a highly efficient capacitor (on top of the motor) that greatly increases pump efficiency by reducing motor amp and watt usage - saving you money on operating costs!.
Advanced engineering provides high efficiency and minimal noise.
115 Volts, with union connections for both suction and discharge ports and a convenient drain plug. Meets or exceeds all CSA and ETL requirements.

See all sketch images for more details, NEMA standard.
60 Hz, 1/2 HP, 115/230 V capacitor start, Single phase, 3500 RPM.
Built-in overload with automatic reset, Stainless steel shaft, Pressure regulator included..
Rotation: clockwise when viewed from motor end, UL778 listed.
Pipe connections: 1.25" NPT suction and 1" NPT discharge, Pressure switch: AS4 preset (30-50 PSI)..
Note : All Pumps, Are Tested By The Manufacture, Prior To Shipping. At Times You Will Encounter A Smalll Amount Of Water Residue Left Over From The Test..

【Item】GPU Mining Power Supply Breakout Board and PCI-E 6Pin to 6+2Pin (Male to Male) cable.
【Performance】Measured maximum can support to 1600W power supply, 12 groups of graphics card 6pin output.
【Safety】The Breakout Board have Solid state capacitor filter, suitable for a variety of server power supply. The line is 16 AWG wire，Able to....
【Compatibility】This item is Compatible with GPU Mining Power Supply -HP 1200W/750W PSU. Such as DPS-1200FB DPS-1200QB PS-2751-5Q HSTSN-PL12....
【What You Get And Shipping】1x Power Supply Unit Breakout Board & 12x PCI-E 6Pin to 6+2Pin Cables & 5x Nylon Cable Ties. SHIPPED FROM THE U.S.....

The Breadboard Kit is convenient for the prototypes and circuit design experiment and other DIY projects. Perfect for Arduino mega board and other programming boards..
Used for electronic experiments and point-to-point DIY soldering projects, can be expandable with pin header and female header, designing your own Arduino kits..
Standard IC spacing 2.54MM hole plated through among the pad can be perfectly working with 3mm&5mm LED Diode kit, Electrolytic Capacitor kit, Monolithic Ceramic Capacitor kit, Resistor kit, etc..
Electroless Nickel Gold finished prevent the copper on PCB from being oxidized and corroded and is good for soldering and touching..
Made of glass fiber FR-4 material, features high heat resistance, corrosion resistance, mechanical strength, insulation..