Reviews Avr Pic Programmer

kuman Compatible For Arduino Raspberry pi Sensor kit 37 in 1 Robot Projects Starter Kits with Tutorials Compatible for Arduino RPi 3 2 Model B B+ K5

  • Professional 37-in-1 Sensor Module Kit, NOT ONLY compatible for ARDUINO, BUT ALSO compatible for raspberry pi RPi 3 2 Model B A A+ B+.
  • Complete Update and common models for arduino Mega 2560 starter kit.
  • Great sensor kit with tutorials compatible for Arduino and raspberry pi..
  • Standard interface can be controlled directly by microcontroller ( 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL logic).
  • Detailed tutorials including project introduction and source code CAN BE PROVIDED..
Check Stock

Painless Performance 80132 Single Pole, Double Throw Relay, 40 Amp

  • ★ The 8-channel relay module is equipped with transistors, diodes and optocouplers to switch higher loads safely, reliably and with little power. The module is also equipped with generously dimensioned relays in order to be able to reliably carry out many switching processes..
  • ★ 5V 8-channel relay module, each relay requires 70mA for switching (switching capacity AC: max. 250V / 10A.
  • ★ 5V 8-channel relay module can be controlled directly with a microcontroller Raspberry Pi, Arduin, 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL logic, etc..
  • ★ The relay acts as a switch that responds to a signal from the Arduin. Because of this, it is widely used in IoT projects to control lights and other electronic devices..
  • ★ Application: MCU control, PLC control, industrial area, smart home.If you need this relay, you can buy it directly. If there is a problem during use, you can contact us at any time to refund or replace it..
Check Stock

sb components Raspberry Pi Breadboard Adapter Development Raspberry Pi Expansion Board, GPIO Breakout Adapter Plate Breakout Mini for Raspberry Pi 4B/3B+/3B/2B/B+/A+/Zero and Zero W

  • Air Monitoring breakout, air monitoring module by SB Components.
  • It provide the level of quantity of the suspended particulates with their mass.
  • It has a powerful and hi-tech PMSA003 sensor that provides the information of suspended particulate matter.
  • It communicates via UART(serial) with the standby current ≤200 Microampere(μA) of the sensor.
  • Compatible with Raspberry Pi, Beaglebone, Arduino, STM32, PIC, AVR, ARM, etc..
Check Stock

GeeekPi 5 Pack Geared Stepper Motor 28BYJ-48 5V Stepper Motor + Uln2003 Motor Driver Board + Dupont Wire Jumper Wires Ribbon Cables Compatible with Arduino

  • 5pcs Stepper motor and driver board compatible with arduinoIDE 2560 1280 DSP ARM PIC AVR STM32 Raspberry Pi..
  • Stepper motor with a standard interface could be connected with Driver Board easily.
  • A, B, C, D four-phase LED indicates the status of the stepper motor work..
  • 5 line 4 phase can be used for ordinary ULN2003 chip driver, connect to the 2 phase , support the development board, with convenient use, direct docking..
  • Package Includes:5 x Stepper Motor,5 x ULN2003AN Driver Board,30 x Female-to-female jump wire.
Check Stock

SunFounder 2 Channel DC 5V Relay Module with Optocoupler Low Level Trigger Expansion Board Compatible with Arduino R3 MEGA 2560 1280 DSP ARM PIC AVR STM32 Raspberry Pi

  • 5V 2-Channel Relay interface board, and each one needs 15-20mA Driver Current.
  • Equiped with high-current relay, AC250V 10A.
  • Standard interface that can be controlled directly by microcontroller (compatible with Arduino ,Raspberry Pi, 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL logic).
  • Indication LED's for Relay output status.
  • Size: 50.5mm(L) x 38.5mm(W) x 18.5mm(H)(1.99inch x 1.54inch x 0.73inch).
Check Stock

DGZZI 50pcs Blue 5mm Pitch PCB Mount Screw Terminal Block Connector for Arduino (20pcs 2 Pin + 15pcs 3 Pin + 15pcs 4 Pin)

  • Application: crystal oscillator, IC socket, DIY PCB universal board, Dupont wire, digital tube, buzzer, Arduino UNO board, PIC programming unit, AVR ATMEL programming unit, connector suite, USB TO TLL module, power module, LCD module, RS232 TO TLL module..
  • Package includes: 20 x 2 Pin Screw Terminal Block + 15 x 3 Pin Screw Terminal Block + 15 x 4 Pin Screw Terminal Block.
Check Stock

Valefod DC 5V Relay Module 1-Channel Relay Switch with Optocoupler Isolation High/Low Level Trigger, Pack of 10

  • 【Control Devices】The 1-channel relay module uses genuine high quality DC5V relay and SMD opto-isolator supporting high/low level trigger, widely apply to control various AC/DC appliances, and other devices with large current..
  • 【Load Range】NO(Normally open) maximum load < AC 250V/10A, < DC 30V/10A. Trigger current of opto-isolator: 5mA..
  • 【Fault-tolerant Design】The relay will not operate even if the control line is disconnected..
  • 【Universal Interface】Equipped with screwed terminal plate and fixed bolt holes(diameter: 3.1 mm) on both sides for easy installation..
  • 【High Compatibility】The relay module can be controlled directly by 5V logic signals from microcontroller(8051, AVR, PIC, DSP, ARM, Raspberry Pi, MSP430, TTL logic etc).
Check Stock

Sipytoph 37 in 1 Sensor Kit,37 Sensors Assortment Modules Starter DIY Kit with Box for Arduino Raspberry Pi 4 Pi 3,3B,,RPi A,Model B,B,

  • This sensor kit includes 37 sensor modules for you to learn basic knowledge about Raspberry Pi and sensors..
  • Standard interface can be controlled directly by microcontroller ( 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL logic..
  • Professional 37-in-1 Sensor Module Kit, Not only compatible for Arduino, but also compatible for Raspberry Pi 3,3B+,RPi A,A+,Model B,B+,2..
  • The highest cost performance kit for electronic hobbyist and advanced learners to expand Raspberry Pi and for Arduino programming..
  • With a detachable lattice plastic storage box, it is very easy to store and carry..
Check Stock

SamIdea 2 Pin 3 Pin PCB Mount Screw Terminal Block Connectors,Socket Strips 5.08mm Pitch for Arduino (Pack of 60pcs)

  • ★★★★★ REMINDS: You can separately buy 2 pin or 3 pin from our store,with ASIN: B07DQKSPWC(2PIN) and ASIN: B07DQTG6W5(3PIN). Application: Crystal Oscillator, IC Socket, DIY PCB Universal Board, Dupont Line, Digital tube, buzzer, Compatible with Arduino UNO board, PIC Programming unit, AVR ATMEL Programming unit, Connector Kit, USB to TLL Modules, Power Modules, LCD Modules, RS232 TO TLL Module.
  • ★★★★★ Rated Value : AC 300V, 16A,Pin Number :2&3(Mixed).
  • ★★★★★ Material : ABS Plastic, Electric Parts.
  • ★★★★★ Net Weight : Approx.179g.
  • Package Content : 30x 2P+30x 3p PCB Terminal Block.
  • ★★★★★ 100% satisfaction guarantee.
  • SamIdea is a Registered Trademark, can not sold without authorization..
Check Stock