Reviews Audio Frequency Analyzer

Rigol DSA815-TG Tracking Generator Spectrum Analyzer

WS-6966 Support formal international standard video and audio encoding.
Satlink WS-6966 Satellite Finder Meter has 4.3 Inch High Definition TFT LCD Screen.
Support DISEQC 1.0,1.1,1.2 and 22khz Tone.
Software upgrade via USB port. Easy to carry..
Measurement Type: signal strength,quality, BER, S/N,PWR, MER.
Sound and Light Alarm for Locking Signal.

This is CY7C68013A-56 EZ-USB FX2LP USB2.0 Develope Board Module Logic Analyzer EEPROM，All gpios are led out by 2.54mm standard pin arrangement,....
CY7C68013A-56 chip: low power version, enhanced 51 core, 16kb program data area, main frequency 48mhz, 480mbps high-speed transmission protocol....
Firmware EEPROM: a complete in system programming scheme, which downloads firmware program directly with USB cable, and provides 16K (24LC128) large....
Package Included:1Pcs CY7C68013A-56 EZ-USB FX2LP USB2.0 Develope Board Module Logic Analyzer EEPROM (If the number of products received is incorrect,....
We highly appreciate all customers opinions to improve the selling, also if anything you unsatisfied, please contact us for probable best solution..

3.12 inch OLED music spectrum display analyzer audio level indicator VU METER 1P. Support 8 kinds of display effects (key switch), support time display, temperature and humidity detection..
Spectrum range: full audio range (20HZ~20KHZ).High and low temperature resistance, more suitable for vehicles..
Advantages of OLED screen: Low power consumption, high brightness.
Compared with ordinary LCD screens, OLED has a faster response speed.
OLED is more resistant to vibration than VFD (vacuum screen).
No music input automatically switches to the time display function..
Built-in high-sensitivity microphone, no longer worry about wiring.
It also supports audio line input, it is recommended to use audio line input to obtain more accurate spectrum effects..

ame great performance as the popular MFJ-259C, but with two additional frequency ranges (100-160KHz and 280-520KHz).
Large easy-to-read two line LCD screen and side-by-side analog meters clearly display your information. Super easy to use! Just set the bandswitch and....
Use 10 AA or Ni-MH batteries (not included) or 110 VAC with optional MFJ-1312D (not included).
Adjust your Yagi, quad, loop and other antennas, change antenna spacing and height and watch SWR, resistance and reactance change instantly. You’ll....
Complete ham radio test station with frequency counter, RF signal generator, SWR/Resistance/Reactance/Coax Analyzer, Capacitance/Inductance Meter and....

✔️The SAA-2N/NanoVNA_V2.2 uses a similar user interface to the NanoVNA, but with a different technical architecture, the SAA-2N/NanoVNA_V2.2 does not load the initial calibration data at startup, and does not automatically interpolate the calibration data after the user changes the frequency, and must recalibrate or call back the calibration data after each startup and frequency change. Please read the user manual carefully before use to avoid damaging the device.
✔️Transmission Mearsure S21: 70dB(50KHz-1.5GHz), 60dB(1.5GHz-3GHz). Reflection Measure S11: -50dB(50KHz-1.5GHz), -40dB(1.5GHz-3GHz).
Antenna Analyzer: 1.005(50KHz - 1.5GHz), 1.02(1.5GHz-3GHz).
Flip Display, you can flip the display for your convenience usage.
✔️ NOTE: The new batch of SAA2N analyzers have been upgraded to the laser labeling on the control dashboard, so you might find it difficult to read at the first sight, the former labeling is easy to fade after long-time usage, and we are still working on it. PC Connection: the device can be controlled by PC via VNA-QT software,supported for Linux, Windows (7+), Mac OS planned. It also support Nanovna-Saver for extracting the data for display on a computer, and for saving to Touchstore files.

Two-channel USB digital oscilloscope, spectrum analyzer, and network analyzer (±25V, differential, 14-bit, 100MS/s, 30MHz+ bandwidth).
Two-channel arbitrary function generator (±5V, 14-bit, 100MS/s, 12MHz+ bandwidth).
16-channel digital logic analyzer, pattern generator, and protocol analyzer (3.3V CMOS and 1.8V or 5V tolerant, 100MS/s).
Two input/output digital trigger signals for linking multiple instruments (3.3V CMOS).
Additional instruments including a data logger, impedance analyzer, and power supplies.

Two-channel arbitrary function generator.
Stereo audio amplifier to drive external headphones or speakers with replicated AWG signals.